Whirlpool 4317824 Instrucciones De Instalación

WARNING
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death
or electrical shock.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
NOTE: Before mounting the cord to the dishwasher, check
the electrical requirements and outlet location.
© Whirlpool Corporation 2012
(All Rights Reserved)
INSTALLATION INSTRUCTIONS
for 4317824 Cord Kit
Electrical Shock Hazard
Electrical requirements
If codes permit and a separate grounding wire is used, it is
recommended that a qualified electrician determine that the
grounding path is adequate.
A 120-volt, 60-Hz. AC-only, 15- or 20-ampere, fused electrical
supply is required. Time-delay fuse or circuit breaker is
recommended. It is recommended that a separate circuit
serving only this dishwasher be provided.
Grounding instructions
This appliance must be grounded. In the event of a
malfunction or breakdown, grounding will reduce the risk of
electric shock by providing a path of least resistance for
electric current. This appliance is equipped with a cord having
an equipment-grounding conductor and a grounding plug. The
plug must be plugged into an appropriate outlet that is installed
and grounded in accordance with all local codes and
ordinances.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or service representative if
you are in doubt whether the appliance is properly grounded.
Do not modify the plug provided with the appliance; if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
Kit Contains:
1 Power Cord 5-1/2'
3 Wire Connectors
1 Protective Grommet
1 Metal Strain Relief
(clamp type connector)
Tools Required:
1 Phillips Screwdriver
1 Pliers
1 Flat Blade Screwdriver
1 Nut Driver or Hex Socket 1/4"
Instruction Sheet 4317825 Rev. E 7/12
(continued)