Motion Sensor; Technical Data - Probuilder 69911 Manual De Instrucciones

MOTION SENSOR

Introduction
To get the most out of your new motion
sensor, please read through these
instructions before use. Please also save the
instructions in case you need to refer to them
at a later date.
The motion sensor is an energy-saving
product. It uses infrared energy from people
as a control signal to turn on the connected
equipment when someone enters the
sensor's detection � eld.

Technical data

Voltage:
Angle of detection:
Frequency:
Operating temperature:
Ambient light:
Operating humidity:
Operating time on detection of motion:
Installation height:
Motion speed on detection:
Nominal load:
Detection range:
Sensor suitable for:
- 69908 Work light 10W
- 69909 Work light 20W
- 69910 Work light 50W
18
100-240 V~
160°
50/60 Hz
-20 to +45 °C
10-2000 lux (adjustable)
<93% RH
min.: 10 sec ± 3 sec
max.: 7 min ± 3 min
1.8-2.5 m
0.6-1.5 m/s
100 W (LED light)
2-10 m (<24 °C)
(adjustable)
Installation
1. Turn off the power.
2. Unscrew the cap on the light and
remove the plug. The sensor can then be
connected to the light.
3. Switch the power on again.