Imation DataGuard T5R Manual De Instrucciones página 8

2. Press the power button.
Note: It takes about a minute to boot the DataGuard Appliance, and it
is fully booted when the System Status LED turns blue and the buzzer
beeps one time.
1.6 ObTAIN THE IP ADDRESS
1.7 SET THE IP ADDRESS
If you wish to modify the network settings, you can do so using the LCD:
1. Press the Enter button to display the Network Setup option on the LCD.
2. Press the Select Button to select the options and then press the Enter button
to change the setting values.
3. When done, select OK and press the Enter button to apply the
networking configuration.
8