Perel WC200 Manual Del Usuario página 3

4. Powering the Clock
This device contains an internal rechargeable battery. When the device reaches end-­of-­
life, it must be disposed of in accordance with local regulations.
Your clock can be powered through a battery (not included) or through an AC/DC
adapter. Plugging the adapter into the clock will simultaneously recharge the battery.
A discharged battery takes 20 hours to fully recharge and will operate for 4 hours.
Battery
Connect the red wire with the red terminal;; connect the black wire with the black
terminal.
Adapter
Next, insert the adapter plug into the input. Connect the adapter to the mains. Switch
on the clock.
5. Operation
5.1 Timer
Press CLOCK/TIMER and select the TIMER mode.
Counting Up
1. Press GO/STOP and select STOP.
2. Press TIMER SET/INTERVAL SET and select TIMER SET.
3. Clear any displayed time if necessary with HOURS/MINUTES or
MINUTES/SECONDS. Press the button once to increase, hold the button pressed to
decrease.
4. Press GO/STOP and select GO. The display will now count up (up to 99:59, after
which it will return to 00:00 and continue counting). Press GO/STOP and select
STOP to stop. Reset the time to zero by pressing 12HR/24HR/RESET.
V. 01 28/05/2018
WC200
3 ©Velleman nv