GE 98209 Guia De Inicio Rapido

USB 2.0
4 Port Hub
Installation
1. Plug the hub into an available USB port on
your computer.
2. Plug your devices into the open USB ports on
the hub
Troubleshooting
Problem Solution
The USB hub Ensure your computer and operating
does not work. system is USB compatible. Please check
your equipment and operating manuals.
Connected Some USB devices require more power
USB devices than your computer can provide.
operate Connect any external power sources to
erratically or all applicable USB devices. If this does
not at all. not solve the issue, unplug each
connected device until the hub is working
properly.
If you are having trouble with your hub or it is not
working properly, please contact Jasco Products
Company at www.jascoproducts.com or at
1-800-654-8483 Option 4 if prompted.
One Year Limited Warranty
Jasco Products Company warrants this product
to be free from manufacturing defects for a
period of one year from the original date of
consumer purchase. This warranty is limited to
the repair or replacement of this product only
and does not extend to consequential or
incidental damage to other products that may
be used with this unit. This warranty is in lieu of
all other warranties express or implied. Some
states do not allow limitations on how long an
implied warranty lasts or permit the exclusion or
limitation of incidental or consequential damages,
so the above limitations may not apply to you.
This warranty gives you specific rights, and you
may also have other rights which vary from state
to state. If unit should prove defective within the
warranty period, return prepaid with dated
proof of purchase to:
Jasco Products Company
10 E Memorial Rd, Oklahoma City, OK 73114
FCC Statement
Notice: Federal Communications Commission
(FCC) requirements, Part 15 This equipment has
been tested and found to comply with the limits
for a class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
CAUTION: Any changes of modifications not
expressly approved by the grantee of this device
could void the users authority to operate the
equipment. This device complies with Part 15 of
the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not
cause harmful interference, and (2) this device
must accept any interference received, including
interference that may cause undesired operation.
GE is a trademark of General Electric Company
and is used under license to
Jasco Products Company LLC,
10 E. Memorial Road, Oklahoma City, OK 73114
www.jascoproducts.com
98209-1