SNOWJOE SUNJOE 24V-300WI Manual Del Operador página 10

NOTE: For the optimal charging efficiency, it's
recommended to charge batteries in the power station.
Powering/Charging Appliances
m
WARNING!
Do not insert a nail, wire, etc. into any
receptacle. Otherwise a circuit short may cause smoke or fire.
1. Mount battery pack(s) securely in any battery
compartment(s). The power station can work with 1 - 4
battery pack(s) to provide different power output.
NOTE: For optimum performance, fully charge all
batteries before use.
2. Press the On/Off button to turn on the power station. The
power station will be in self-check mode for less than 1
second (Fig. 6). Then the LCD screen will be in standby
mode (Fig. 7).
Fig. 6
LCD Screen
(Self-check mode)
Fig. 7
LCD Screen
(Stand-by mode)
NOTE: If the working battery status icon doesn't
recognize any inserted batteries, remove the batteries
and reinsert.
3. Connect the devices you want to power or charge into the
power station's USB receptacle and/or AC receptacle
(Fig. 8). The corresponding USB working status icon
will light up on the LCD screen when there's devices
connected to any of the USB receptacles.
Fig. 8
NOTE: During use, the batteries in the compartments will
be discharged one by one in the direction as shown next.
If any compartment is empty, the power station will jump
to discharge the next available battery (Fig. 9).
NOTE: If the power station is turned on without any
appliance be connected, and both the spotlight and the
reading lights are off for more than 2 minutes, the power
station will shut down automatically .
On/Off button
m
WARNING!
power station's AC port.
4. During discharge mode, the working battery status icon
will flash to indicate which battery is currently working.
Other stand-by battery pack(s)'s icon will lit up. The
LCD screen will also show the remain power capacity in
percentage and the current output (Fig. 10).
Fig. 10
LCD Screen
(Discharge mode)
10
Do not insert the AC charger's plug into the
Fig. 9