Publicidad
Idiomas disponibles
Idiomas disponibles
SIDE MOUNTING
1. Attach crossbar to junction box. Set the crossbar so
that the longer blade is touching the junction box.
(See Figure 3)
Figure 3
Plastic
Housing
EXIT Panel
Directional Arrow
2. Open the EXIT housing.
(See Figure 4) Feed the
transformer input leads
through side hole, being
sure to secure wire into wire
guides molded at the edges
of the sign. (See Figure 3)
3. Attach sign to canopy by inserting canopy into sign
at an angle, then twisting to secure. (See Figure 3)
4. Make the proper supply lead connections. If using
120VAC, connect the black and white leads to the
building utility. If using 277VAC, connect the orange
and white leads to the building utility. Cap off
unused wire. If the unit is self-powered, be sure to
snap battery connector together.
5. Feed excess wire into junction box and align holes in
canopy with holes in crossbar. Use screws supplied
to tighten canopy to crossbar so canopy is securely
fastened and tight against wall. (See Figure 3)
6. Snap in arrows to EXIT panel as required. Then snap
EXIT panel to housing: top first then bottom.
CAUTION! Battery Connector is shipped
disconnected. Snap connector into
socket at installation. (See Figure 7)
Use Manual Battery Test Switch on base of unit
to test. Red LED indicates normal operation.
(See Figure 8)
PAGE 2 OF 6
INSTALLATION CONTINUED
Back Plate
Canopy
Wire Nuts
Diffuser
Crossbar
Crossbar Screws
Snap-in
(not included)
Figure 4
CEILING MOUNTING
1. Attach crossbar to
junction box. Set
the crossbar so that
the longer blade
is touching the
junction box.
(See Figure 5)
2. Open the EXIT
Junction
housing. (See
Box
Figure 4) Feed the
transformer input
leads through top
hole, being sure
to secure wire into
wire guides molded
at the edges of the
sign.
3. Attach sign to
canopy by inserting
canopy into sign at
an angle. Twist to
secure. (See Figure 6)
4. Make the proper
supply lead
connections. If
using 120VAC,
connect the black
and white leads to the building utility. If using
277VAC, connect the orange and white leads to
the building utility. Cap off unused wire. If the unit
is self-powered, be sure to snap battery connector
together.
5. Feed excess wire into junction box and align holes
in canopy to crossbar so that canopy is securely
fastened and tight against the ceiling.
6. Snap in arrows to EXIT panel as required. Then snap
EXIT panel to housing: top first, then bottom.
BATTERY
Battery
0 2 3 3 4 5 6
Connector
Socket
1-800-295-5510
uline.com
Figure 5
% ¥ ¡ ¦ § ¨ ¢ ¡
1 ¢
1 ¡ ¢ £ ¤
§ ¨ ¦
Housing
¡
Figure 6
Figure 7
Red LED
¢ ©
! ¨ " " ¥
Snap-in
Directional Arrow
# $ & ' ( )
Figure 8
Manual Battery
Test Switch
0621 IH-1663
Publicidad
