Portfolio 00909 Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
1. Loosen the screws (AA) from the bottom plate (B)
with a screwdriver (not included). Insert the
back panel (A) into bottom plate (B) and secure
together by tightening screws (AA) with a
screwdriver.
Hardware Used
AA Screw
2. Put the spikes (C) through the holes on the bottom
plate (B), and then hammer the spikes (C) into
ground to fasten the stand. Make sure the stand
is securely fastened to the ground before placing
transformer (sold separately) on to the stand.
CAUTION: DO NOT hammer the spikes (C) upright.
Hammer the spikes (C) with a angle off vertical.
x 2
4
1
B
2
C
hole
Lowes.com/portfolio
A
AA
B