Dimplex BFSL33 Manual Del Propietário página 8

Operation
Wall Mounted Controls
The fireplace can be installed with
wall mounted controls. These
controls include wall switches
and thermostats. (see installation
guide for details)
1 . Wall Mounted Switches
This model may be installed
so that a wall mounted switch
energizes the firebox and flame,
(Main Power Switch must be
in the ON position). A wall
mounted switch may also be
used to override the flame image,
(Main Power Switch must be
in the ON position in coordina-
tion with any main power wall
mounted switch).
2 . Wall Mounted Thermostat
This unit may be installed so
that a wall mounted thermostat
can adjust the heat temperature
to your individual requirements.
Please refer to thermostat manu-
facturers operation Instructions.
3 . The Temperature Cutout
Switch
The heater on the fireplace is
8
protected with a safety device to
prevent overheating. Should the
heater overheat, a temperature
cutout will shut the fireplace off
and it will not come back on with-
out being reset.
To reset, switch the main power
switch (Figure 2) to OFF and wait
10 minutes before switching it to
ON.
CAUTION: If the heater
continuously resets, disconnect
the power at the main service
panel and call your local dealer.
!
NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial heating
of internal heater parts and will
not occur again.
www.dimplex.com