Periodic Maintenance - AllFitHD AF-80TBS Instrucciones De Montaje

Before Using Broadcast Spreader:
1. Read all Safety Rules found on page 1.
2. Make sure the drop holes in the bottom of the hopper are fully open with the
Rate Control handle set on #30. If not, adjust control cable to allow for a
fully open hopper at position #30.
3. Obtain proper setting for material to be used from the Setting Matrix.
4. Move stop bolt on range gauge assembly to proper setting.
How to use Broadcast Spreader:
1. While moving forward, push control lever forward to the stop bolt. To stop,
pull lever back to close flow holes before you stop moving.
2. When finished, empty any remaining material from hopper.
SUGGESTED SPREAD PATTERN
FULL RATE SETTINGS

Periodic Maintenance:

• Tighten fasteners as needed before each use
• Thoroughly wash spreader before storage
Operating Instructions
HALF RATE SETTINGS
6