Care And Maintenance - BENDEL Tornador-Classic Z-010S Manual De Instrucciones

Operating instructions:
1. Remove loose soiling from the surface you wish to clean (brush or vacuum clean)
2. Turn the green rocker lever into the vertical position to activate the (cleaning) liquid in
the bottle
3. Important: Hold the cleaning spout at a distance of only 1-3 cm from the surface you
are cleaning.
4. Press the "trigger" all the way; move the Tornador Gun slowly with circular motions
over the surface you are cleaning.
5. Turn the green control switch into the horizontal "air only" position, press the trigger
and dry the surface you have cleaned.
6. To remove any remaining moisture, wipe the cleaned surface with a dry cloth.
7. Clean the spout as follows: Turn the green control switch to the horizontal "air only"
position, hold the cleaning nozzle in a bucket and press the trigger all the way in
order to remove any soiling from the nozzle.

CARE AND MAINTENANCE

Clean the Tornador-Gun after each usage as described in point 7.
REQUIRED AIR RATE
To perform to its full potential, the Tornador Gun requires a constant air pressure of 6-8 bar.
CAUTION:
Constant air rates vary depending on the size and power of the compressor.
Always make sure that the tank and the air hoses are free of impurities of any kind.
2016/01