INSTALLATION INSTRUCTIONS
Combination Receptacle /
USB Charger
APPLICABLE MODEL NUMBER
R1615S21
R1615S30
R1615S36
R1615D21
R1615D30
R1615D36
R1620D21
R1620D30
R1620D36
FEATURES
1. The Receptacle provide two 5V DC powered USB ports with a
total of 2.1/3.0/3.6/4.0A charging current.
2. Charge most compatible electrical device directly without an
adapter.
3. If the devices combined power requirements exceed the power
capacity of the USB ports, the charger will shut down to protect
your electrical devices.
4. Replace a standard single or duplex receptacle.
5. Compatible with USB 2.0/3.0 devices. The USB ports are used
to charge portable electronic devices ONLY (NO data transfer
capability).
6. Back and side wire for easy installation.
COMPATIBILITY
The USB charger is compatible with USB powered devices such as:
• iPad
• iPhone
®
®
• GPS
• Game Systems
• E-Readers
• Blackberry
• Bluetooth
• Headsets
®
APPLICATION
• Cafes
• Labs
• Restaurants
• Bedroom
• Salons
• Kitchens
• Libraries
• Meeting Rooms
• Airport Lounges
REV 3.0
SPECIFICATION
1.3(33mm)
1.69(43mm)
Receptacle Rating
USB Rating
Wiring Gauge
R1615S40
R1615D40
Operating Temperature
R1620D40
Dimension
WARNINGS AND CAUTIONS
• To be installed and used in accordance with appropriate code
and regulations.
• If you are not sure about any part of these instructions, consult
an electrician.
• To be used with Class 2 connectors with interconnecting cables.
• The Class 2 USB ports are not intended for use with appliances
and supporting products.
• All connected Class 2 output cables must be routed away from
the receptacle slots or any plug / cord inserted into the
receptacle.
• Use this device with copper or copper clad wire only.
AVERTISSEMENTS ET MISES EN GARDE
• Pour être installé et utilisé conformément au code et aux
règlements appropriés.
• iPod
®
• Si vous n'êtes pas sûr d'une partie de ces instructions,
• Mobile Phones
consultez un électricien.
• Tablets
• À utiliser avec des connecteurs de classe 2 avec des câbles
• Digital Cameras
d'interconnexion.
• Les ports USB de classe 2 ne sont pas conçus pour être utilisés
avec des appareils et des produits associés.
• Tous les câbles de sortie de classe 2 connectés doivent être
• Office
éloignés des emplacements de prise ou de toute fiche / cordon
• Hotels
inséré dans la prise.
• School
• Utilisez cet appareil avec un fil de cuivre ou un fil de cuivre
• Workstations
uniquement.
0.29(7.4mm)
1.65(42mm)
15 Amp or 20 Amp, 125V AC
2.1Amp/3.0Amp/3.6Amp/4.0Amp,5V DC
#14 - #12 AWG
-4 to 104℉(-20 to 40℃)
4.17x1.69x1.65" (106x43x42mm)
INSTALLATION
1. WARNINGS AND CAUTIONS: TO AVOID FIRE, SHOCK, OR
DEATH, TURN OFF POWER AT CIRCUIT BREAKER OR FUSE
AND TEST THAT THE POWER IS OFF BEFORE WIRING!
AVERTISSEMENTS ET MISES EN GARDE: POUR ÉVITER
TOUT INCENDIE, TOUT CHOC OU LA MORT, COUPEZ LE
DISJONCTEUR OU LE FUSIBLE ET TESTEZ QUE
L'ALIMENTATION EST COUPÉE AVANT LE CÂBLAGE!
2. This device is to be installed in a wall box measuring at least 3" x
2" x 2-1/2" (standard single gang electrical wall box) and wired in
accordance with NEC article 314 box fill requirements.
3. Connect wires per WIRING DIAGRAM as follows:
NOTE: Back and side wire terminals accept #14-#12 AWG
copper or copper clad wires.
a. To Side Wire (if more than one wire is required on a terminal,
you cannot side wire and must use the backwire option):
Remove insulation from each circuit conductor per strip gage on
device [approx. 4/5" (20mm)]. Loop wires clockwise 3/4 turn
around terminal screws. FIRMLY tighten screws over wire loop
with the torque force among 14-16 in-lbf.
b. To Back Wire: Remove insulation from each circuit conductor
[approx. 3/5" (15 mm)]. Insert straight wires under clamps next to
appropriate terminal screws. Tighten screws FIRMLY with the
torque force among 14-16 in-lbf.
4. Mount device in wall box with screws provided and mount wall plate.
5. Restore power at circuit breaker or fuse. Installation is complete.
WIRING DIAGRAM
Strip Gauge
Side wire:
4/5"
20mm
Hot
Black
Strip Gauge
Back wire:
3/5"
15mm
ELE GROUP CO., LTD
NO.158 CHUANGYUAN ROAD, SIP
SUZHOU, JIANGSU, CHINA 215125
WWW.ELEGRP.COM
Neutral
White
Ground
Green
Cu AI