Bosch GTA 2500 W Professional Manual Original página 23

OBJ_BUCH-854-002.book Page 22 Sunday, January 4, 2009 12:35 PM
22 | English
Extending the Saw Stand
(see figure J)
The saw stand can be extended on both sides.
– Place your long workpiece onto the saw table
of the power tool.
– Release the respective locking knob 4 as re-
quired, and pull the table extension 5 out to
the desired position.
– Retighten the locking knobs again.
Sawing Workpieces of the Same Length
(see figure K)
The length stop 11 can be used for easily sawing
workpieces to the same length.
– Pull the length stop upward to the stop and
position the workpiece support at the de-
sired clearance to the saw blade of the pow-
er tool.
Checking and Adjusting the Basic
Adjustment
After intensive use, the basic settings of the saw
stand must be checked and reset as required, to
ensure safe and proper function.
Experience and appropriate specialty tools are
required for this.
– Remove the power tool with the attachment
sets.
Adjusting Lock 9
(see figure L)
Over time, the lock 9 of support 8 can become
loose.
– Close lock 9.
– Insert a slotted screwdriver between the saw
stand and nut 27.
– Turn the lock in clockwise direction until the
lever for locking can be firmly closed again.
– Remove the slotted screwdriver and check
the adjustment again.
1 609 929 S19 | (4/1/09)
Adjusting the Limit Bolts of Lock 3
(see figures M1 –M2)
Checking:
– Bring the saw stand into the working position
(completely pulled apart).
Both limit bolts 20 must be completely extend-
ed and without a gap between limit bolts and
locking plate 21.
Adjusting:
– Open nuts 28 (16 mm) a quarter turn on
each side of the stand base.
– Tighten the adjustment screw 29 on the side
that has a gap between limit bolt and locking
plate.
If this does not reduce the gap, loosen the
adjustment screw on the other side.
– Repeat the procedure until both limit bolts
are completely extended again and no gap is
between the limit bolts and the locking plate.
– Tighten nuts 28 again.
Transport
The stand base must be folded together for
transport. (see figure N)
– Slide the table extensions 5 all the way in as
well as the workpiece supports 12 and the
length stops 11 all the way down.
– Release lock 9.
– To relieve the limit bolts 20, lightly push the
saw stand downward by the handle 6.
– Release lock 3.
This pulls back the limit bolts that lock the
wheels in place.
– Position one foot on the foot lever 14 and
pull the handle 6 upward with both hands un-
til the limit bolts can engage again on the oth-
er side of the locking plates 21.
– Close the lock 3.
Bosch Power Tools