ARDES AR4W05P Folleto De Instrucciones página 19

will be on in the display) or maximum power (the display will show "- -" and
the indicators light
The timer ( ) pushbutton of the remote control has the same function of the
pushbutton in the control panel.
Set the current time and day (if unit is in stand-by mode or working status):
1. Press "SET" pushbutton: the display show "12" as default hour.
2. Press + or - pushbuttons to select the current time (hours).
3. Press "SET" pushbutton again: the display show "30" as default minutes.
4. Press + or - pushuttons to select the current time (minutes).
5. Press "SET pushbutton" for the third time: the display show "d7" as default
day of the week.
6. Press + or - pushbuttons to select the current day: d1 (Monday), d2
(Tuesday), d3 (Wednesday).....d7 (Sunnday).
7. Press "OK" pushbutton to confirm the settings.
-
Attention: the settings of time and day will be stored till the unit is in
stand-by mode or working status. In case of power failure, removing
the plug from the wall socket, or switching off the appliance using the
On / Off switch (1), all settings will be lost.
Set the automatic working mode (if unit is in working status):
- Push + or - pushbuttons to set the desired room temperature (from 10°C to
49°C). The display will show 23°C as default. Each pressure the temperature
increases or decreases by 1 ° C. If the automatic mode is set, the °C indicator
lights up in the display.
During automatic working mode, the unit select automatically the power
according to the difference between the desired room temperature and the
ambient temperature. In this working mode the appliance can switch between the
different power levels (ventilation, power I and II) and standby even repeatedly.
The selected power level is always shown on the display.
-To deactivate this function, press the speed (
desired function (fan only, power I or power II). Once the automatic working mode
is deactivated the °C indicator light will turn off in the display.
- Warning: the unit switch in stand-by mode after 12 hours of continuous
operation.
Set the weekly program (if unit is in working status):
The weekly program allow to set 6 working period (from P1 to P6) per day. For
each working period is possible set the time when unit should turn on (Time/On)
and when the unit should be in stand-by mode (Time/Off).
Furthermore, the desired temperature can be set for each day.
1. Push "P" pushbutton; the light of P light up in the display
will be on in the display).
19/90
) pushbutton and select the