Denver CRB-618 Instrucciones De Uso página 5

Changing the Bluetooth connection the new mobile phone
Press and hold the Pair button(3) for 3 seconds. The pair indicator will flashes
quickly and the radio will produce a confirmation tone. Select and confirm the
pairing on your new mobile phone.
**Pairing code: DENVER CRB-618
Note:
Some mobile phones may connect and disconnect as you make and end calls.
This is not an indication of a problem with your unit.
AUX IN
Requires a 3.5mm audio cable (not included).
1. Connect the 3.5mm audio cable to the Line In on the unit and an audio
output on an MP3 player or other audio source.
2. Press the Source button to switch to Aux In mode.
3. Use the native controls on the connected MP3 player or other audio source
to play and control audio played through the clock radio.
USB CHARGING SOCKET
USB devices: DC 5V
The product functions as a charger for your mobile phone and USB device.
The connector or the USB charging cable (not supplied).
Specifications
Frequency range :
Battery backup :
Power Adaptor:
Resetting
If the system does not respond or exhibits erratic or intermittent operation, you
may have experienced an electrostatic discharge (ESD) or a power surge that
triggered the internal microcontroller to shut down automatically. If this occurs,
simply disconnect the ac power cord and remove the system backup battery,
wait for at least 3 minutes and then setup the unit again as if it is a brand new
unit.
87.5 – 108 MHz.
3V (CR2032 Flat Lithium battery x 1) not included.
Input AC 100-240V 50- 60 Hz.
Output DC 5V 1500mAh.