Extension Cord - Desa PP100 Instrucciones De Instalación

6. Position blower assembly on cabinet back
panel with inlet over slots in panel, and out-
let pointed towards front (see Figure 4).
7. While holding blower against inside of
back panel, attach blower with two #10
screws (supplied) as shown in Figure 4.
8. Attach blower switch to upper baffle with
two #8 screws (see Figure 4).
9. Reattach front panel to heater using four
painted screws.
10. Complete installation of heater by follow-
ing the steps in your owner's manual.
Back
Panel
Baffle
Blower
Blower
Outlet
Figure 4 - Front of Heater, Attaching Blower
WALL MOUNTING INsTRUCTIONs
FOR MODELs WITh MOUNTING
BRACkET
1. Mount heater to wall by following steps un-
der Installing to Wall in owner's manual.
2. Plug power cord of blower into grounded
outlet.
DESA Heating Products warrants this product to be free from defects in materials and workmanship for
one (1) year from the date of first purchase, provided that the product has been properly operated.
This warranty is extended only to the original purchaser. DESA Heating Products shall either replace the
product or refund the full purchase price. Warranty service is available only through authorized dealers.
This warranty does not apply to the failure of any part resulting from accident or misuse by the owner,
nor does it apply to use in commercial applications.
To the full extent allowed by the law of the jurisdiction that governs the sale of the product: this express
warranty excludes any and all other expressed warranties. The above expressed warranty is in lieu of
all other warranties either expressed or implied including but not limited to the implied warranties of
merchantability and fitness for a particular purpose. DESA Heating Products' liability is hereby limited to
the purchase price of the product, and DESA Heating Products' shall not be liable for any other damages
whatsoever including indirect, incidental, or consequential damages.
Some states do not allow a limitation on how long an implied warranty lasts, or an exclusion or limitation
of incidental or consequential damages, so the above limitation on implied warranties, or exclusion or
limitation on damages may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
For information about this warranty write:
2
Screws
Slots
Fan
Switch
Power Cord Placement
lImIteD warranty
www.desatech.com

ExTENsION CORD

Use extension cord if needed. The cord must
have a three-prong, grounding plug and a
three-hole receptacle. Make sure cord is in
good shape. It must be heavy enough to carry
the current needed. An undersized cord will
cause a drop in line voltage. This will result in
loss of power and overheating. Use a No. 16
AWG cord for lengths less than 50 feet.
CAUTION: Verify proper op-
eration after servicing.
OPERATING BLOWER
The blower is connected to a thermostat.
When unit heats up, the blower will operate.
A few minutes after unit cycles off or is turned
off, blower will shut off. Blower will cycle on
and off in this manner. Note: If you have a
heater with a thermostat, the heater and
blower will not turn off and on at exactly the
same time. Blower cycle times will vary with
heat setting selected.
110/115
V.A.C.
Figure 5 - Wiring Diagram For Blower
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004, USA
Black
Green
White
Accessory
Thermostat
Sensor
Switch
Blower
Motor
Black
White
Green
119355-01A