To Reset To Factory Default; Anti Tamper Alarm; Sound And Light Indication; Detailed Programming Guide - Retekess T-AC03 Manual Del Usuario

To Reset to Factory Default

a. Disconnect power from the unit
b. Press and hold # key whilst powering the unit back up
c. On hearing two "Di" release # key, system is now back factory settings
NOTE: note only installer data is restored, user data will not be affected

Anti Tamper Alarm

The unit uses a LDR (light dependent resistor) as an anti tamper alarm. If the keypad is removed
from the cover then the tamper alarm will operate.

Sound and Light indication

Operation Status
Power on
Stand by
Press keypad
Operation successful
Operation failed
Enter into programming mode
In the programming mode
Exit from the programming mode
Open the door
Alarm

Detailed Programming Guide

1. User Settings

To enter the programming mode
To exit from the programming mode
Note that to undertake the following programming the master user must be logged in
To change the master code
Setting the working mode:
Set valid card only users
Set valid card and PIN users
Set valid card or PIN users
Red Light Green Light
- Bright
Bright
-
- Bright
-
Bright
-
Bright
- Bright
Bright
* Master code #
999999 is the default factory master code
*
0 New code
The master code can be 6 to 8 digits long
3 0 #
3 1 #
3 2 #
4
Yellow Light
-
- -
- -
-
- -
- -
- Bright
- -
-
- -
# New code
Entry is by card only
Entry is by card and PIN together
Entry is by either card or PIN (default)
Buzzer
Di
-
Di
Di
DiDiDi
Di
Di
Di
Alarm
#