Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Connect hose fitting to torch by turning clockwise. Hand tighten only. Do not force.
2.
Place belt hook over cylinder valve.
3.
Turn off the adjustment knob by turning clockwise until it stops. Hand tighten only. Do not force.
4.
Thread the cylinder onto the fuel valve by turning clockwise until it stops. Hand tighten only. Do not force
WARNING
•
Always inspect connections for leaks at cylinder and torch. Use soapy water to inspect for leaks (leaks will form bubbles).
•
Never use torch if leaking.
•
Always use torch in well ventilated areas.
•
DO NOT USE THE TORCH IF THE HOSE SWELLS DURING OPERATION. THE HOSE MAY RUPTURE UNEXPECTEDLY AND
CAUSE INJURY OR DAMAGE. If the hose swells, stop using the torch. Disconnect the fuel valve from the cylinder and then re-open the
valve to bleed the hose. Replace the torch assembly before relighting.
REMOVE CYLINDER FROM TORCH
WHEN NOT IN USE
1.
Turn torch valve OFF (when applicable).
2.
When torch is cool, disconnect cylinder. Store torch and hose separately from cylinder and out of reach of children.
3.
Also observe cautions on cylinder label.
4.
Do not expose cylinders to temperatures in excess of 120 °F.
5.
Store cylinders in well ventilated areas.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET CES INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS DE ATENÇÃO E INSTRUÇÕES
1. Turn off the fuel valve knob. Light torch or appliance to burn out remaining gas in hose. Thread
cylinder out of fuel valve by turning counter-clockwise.
2. Disconnect hose fitting from torch by turning counter-clockwise.
ADDITIONAL WARNINGS
•
Make sure the torch is cool before tightening or removing burner head or before installing or
removing accessories.
•
Check all joints and couplings periodically to insure against loose connections. With valve
open, without lighting, test all connections with soapy water. If bubbles appear, gas is leaking
and torch must be repaired. NEVER USE A FLAME TO CHECK FOR LEAKS. Make this test
in a well ventilated and spark-free area and where there are no open flames.
•
In cold weather the size of the flame will be smaller. To produce a larger flame, pre-warm the
cylinder to room temperature prior to use.
200 Old Wilson Bridge Road
Columbus, OH 43085
ASSEMBLY
DISASSEMBLY
STORAGE
419925
02/20
MagTorch.com
Publicidad
Tabla de contenido
