Connection Diagram - PNI Clementine 9440 Manual Del Usuario

Connection diagram

Troubleshooting
Fault
Power is OFF
No display
on LCD
No sound
Low sound or
not clear
Sound is mono
Note: Technical data is subject to change without prior notice.
Reason
1. Power supply is not properly connected.
2. The fuse is broken or the power wire is not
connected.
1. Yellow wire is not connected with the igni-
tion lock wire.
2. The fuse in the yellow wire is broken.
1. The power is not connected.
2. Speaker wires are not connected.
3. There are no files on the USB memory, or the
SD/MMC memory card.
4. SD/MMC card or USB memory is not properly
connected.
1. Battery power is low.
2. Antenna is not properly connected.
1. One of the speakers is not connected.
2. Amplifier circuit is broken.
Connect the power supply properly.
Chech the fuse and the power wire.
Check if the yellow wire is connected
with the ignition lock wire.
Replace the fuse.
Replace power supply plug.
Check speaker wiring.
Check SD/MMC memory card or the
USB memory and clean it with ethyl
alcohol if it's dirty.
Replace car battery.
Check antenna connection.
Check and connect all speakers.
Replace circuit.
10
Solution