Adding A Channel; Changing Channels; Deleting A Channel - Gallagher i Serie Instrucciones

ADDING A CHANNEL

To add a new energizer to the list of channels, complete
the following:
1. Hold down any two buttons (ON/OFF/Inquiry) for 3
seconds or more.
The Remote display scrolls through all the "filled"
channels. Before returning back to 1, a "new" channel
is indicated by the magnifying glass icon
this icon is displayed, release the button.
2. Hold the fence connection slot against a wire connect-
ed to the new energizer.
3. Press any button to start the automatic tuning
process.
On successful tuning, the magnifying glass icon is
cleared and the new energizer channel number is
displayed. If the tuning is unsuccessful, the reverse
lightning bolt symbol will flash.
Handy Hint: To remember which channel number is set to
each energizer, use the table at the back of this manual to
record it.

Changing channels

1. Hold down any two buttons for 3 seconds.
The Remote display scrolls through all the "filled"
channels.
2. Release the buttons when the energizer channel you
wish to communicate with is displayed.

Deleting a channel

1. Hold down any two buttons for 3 seconds.
The Remote display scrolls through all the "filled"
channels.
2. Release the buttons when the energizer channel you
wish to delete is displayed.
3. Press and hold any two buttons for 6 seconds.
After 3 seconds the channel number will start to flash
for a further 3 seconds. If both the buttons are held
until after the flashing period, the channel will be
deleted and the first available channel displayed.
Note: When the battery is removed from the Remote,
all channel information is retained. However, when the
battery is replaced, the channel selection will reset to the
lowest configured channel.
. Once
11