BAUKER NLC02 Manual De Instrucciones página 14

fig 1
ON OFF
NOTE:
• Always turn off the tool before installing or replacing the batteries.
• Remove the batteries from the tool when not using it for extended
periods.
• The AAA batteries should match each other in brand and type.
• Do not mix old and new batteries.
• Remove depleted batteries immediately, and dispose of them
according to the laws and regulations governing your community.
Using your self-levelling cross-line laser level
Your self-levelling cross-line laser level has two working modes
Self-levelling mode and Lock (manual) mode.
Self-levelling mode
In this mode, the tool will level itself if it is within ±4° of horizontal.
1. Place the self-levelling cross-line laser level on a flat, smooth
surface that is within ±4° of horizontal.
2. Turn the tool on by sliding the power switch to the up position.
The self-levelling cross-line laser level will automatically level within
5 seconds.The LED indicator will shine green.
3.When the self-levelling cross-laser out of levelling，the LED will
turn to red and the laser line will blink.
4. To turn off the laser lines, slide the switch to down position.
Latch
fig 2
CROSS LASER LINE
WARNING!
When turning the laser on, always be aware of protecting your eyes
and the eyes of those around you. Never point the laser light at
anyone's face, including your own.
Applications
Your self-levelling cross-line laser level can be hand-held for point-
marking and simple alignment by sight . It is ideal for the following
applications:
• Hanging pictures, photos, or artwork on walls
• Wallpapering and stencil work
• Framing doors and windows
• Installing electrical wiring and pipes
• Mounting wall fixtures, electrical outlets, switches and lighting
• Installing a drop ceiling
• Painting
• Installing closets
• Laying tile and flooring
Working Advice
Working with the Tripod (see figure A)
A tripod 10 offers a stable, height-adjustable measuring support.Place
the measuring tool via the tripod mount 8 on to the 1/4" (0.635 cm)
male thread of the tripod and screw the locking screw of the tripod
tight.
Holding Laterally against a Wall or Object (see figure B)
For quick checking of heights, the measuring tool can be held against
a vertical wall,cabinets, etc. Take care to hold the measuring tool
straightly and calmly.