Publicidad
ADD SALES CODE TO VEHICLE IN DealerCONNECT
1. Log on to https://dealerconnect.chrysler.com.
2. In the "Service tab"-"Warranty Administration" box -"Vehicle Option Updates" screen, enter the vehicle VIN
and add the sales code JKR (Remote Tailgate) as a "Dealer Installed Option".
3. Confirm that the new sales code has been successfully added to the VIN.
Using the wiTECH scan tool connected to the vehicle, perform the following steps in the order outlined below.
NOTE: The following steps outlined were performed using wiTECH 2.0
1. Restore Vehicle Configuration
a. From the Vehicle Select Screen, navigate to the Vehicle Topology Screen or ECU List
b. From the ACTIVITES section of the left margin, select option "GUIDED DIAGNOSTICS"
c. Select option RESTORE VEHICLE CONFIGURATION
d. Follow prompts on the screen to complete this procedure
e. When finished, cycle ignition to OFF, then cycle ignition to RUN (without cranking the engine)
f. Leave ignition in Run for minimum of 60 seconds, then cycle OFF
g. Now cycle ignition to RUN (without cranking engine)
h. Clear ALL DTCs
NOTE: This procedure will require you to log into DealerCONNECT and enter a PIN when requested.
The PIN is temporary and will be active for 12 hours. After 12 hours, a new PIN
from DealerCONNECT.
2. Programming New FOBIKs
a. From the RFH Screen, Select MISC FUNCTIONS Tab
b. Select option PROGRAM IGNITION FOBIKs
c. Review message on the screen and press CONTINUE
d. Review message on screen and press CONTINUE
e. Enter PIN and press CONTINUE
f. Review message and follow procedure on WiTECH screen. Press CONTINUE
g. Continue following procedure on WiTECH screen. Press Continue
h. A screen may appear showing the progress of the FOBIK programming – allow to complete to 100%
i. Message on screen will appear that FOBIK programming was successful. Follow procedure on screen
to program another FOBIK (press CONTINUE) or if finished (press CANCEL)
At any time during the session, a FOBIK (ADMIN or KeySense) can be programmed by returning to the beginning
of this section and following the procedure.
3. Test Remote Tailgate Release
4. CLEAR ALL DTCs
a. Cycle ignition to the OFF position
b. Start the engine and turn the steering lock to lock
c. Cycle iginition off then cycle to the ON/RUN position (do not start engine)
d. Check for any DTCs
e. Clear all DTCs
4-20-18
will need to be obtained
K6862788
3
Publicidad
