Regulatory Statements - Unova Intermec MicroBar 9730 Guía De Inicio

Regulatory Statements

Intermec hereby declares that the following product has been tested and found compliant with the below listed standards as
required by the EMC Directive 89/336/EEC as amended by 92/31/EEC and by the Low Voltage Directive 73/23/EEC as
amended by 93/68/EEC:
EN55022 (1992)
USA: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CANADA: This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du
Canada.
AUSTRALIA-NEW ZEALAND: This equipment has been tested and found to conform to the Australian
EMC framework concerning Class B digital devices, prescribed by the Australian and New-Zealander
standard AS/NZS 3548.
The information contained in this manual is for informational purposes only and is subject to change without notice. No
part of this leaflet may be copied or reproduced in any manner without the prior written permission of Intermec
Technologies Corporation.
© Intermec Technologies Corporation All Rights Reserved
The word Intermec, the Intermec logo, MicroBar and EasySet are either trademarks or registered trademarks of Intermec.
Throughout this manual, trademarked names may be used. Rather than put a trademark (™ or ®) symbol in every
occurrence of a trademarked name, we state that we are using the names only in an editorial fashion, and to the benefit of
the trademark owner, with no intention of infringement.
NorthAmerica/Asia Pacific/Latin America • 6001 36th Avenue West • PO Box 4280 • Everett WA 98203-9280 • tel +1 425 348
2600 • fax +1 425 348 2833 • U.S. service and technical support, tel 1.800.755.5505 • Canadian service and technical support,
tel: 1.800.688.7043
Europe/ Middle East / Africa • Sovereign House • Vastern Roadtel Reading RG1 8BT • England • Ttel +44 118 987 9420
• fax +44 118 987 9416
Internet • http ://www.intermec.com
E-mail • info@intermec.com
EN50082-1 (1997) EN60950 (1993)
12
© 8/98 Intermec Technologies Corporation. All rights reserved. 0-230049-01
N309