weasy citru6 Manual De Instrucciones página 7

To change the position of the spout, move the spout upwards or downwards with a light pressure.
Note
After use, the spout must always be in the raised position
.
INITIAL START-UP
l Rest the appliance on a horizontal and stable surface away from heat sources.
l Assemble the appliance by following the procedure indicated.
l Use cone in relation to the size of the citrus fruit and move the spout of the container to the
desired position: raised or lowered (refer to the section on "Accessories and Container Spout")
l Completely unwind the power cord and connect the plug to power outlet.
l Cut the citrus fruit in two sections and press each half lightly on the juicing cone. The juicer starts
to turn. Simply remove the pressure from the cone to stop the juicer.
Tips and suggestions
To get as much juice as possible from the fruit, press the citrus fruit onto the cone several times
instead of keeping it continually pressed.
Attention!
l Too much pressure on the cone may cause the motor to block.
l Do not let the juicer operate for more than two minutes consecutively.
l Wait five minutes between each use to allow the motor to cool to room temperature
l Do not let the power cord hang from the bench top.
l Do not insert sharp cutlery or objects while the cone is moving.
l After use, disconnect the plug from the power outlet and place the spout in a raised position.
.