Appearance Introduction; Annual Product Calibration; Product Notes And Precautions - UPRtek MK30S PREMIUM Manual Del Usuario

1.2 Appearance Introduction

Optical Sensor
Flicker Sensor
Strap Hole 4.3" touch panel
Measure Key
Battery Cover
If the system crashes, please press the power key for 3 seconds to turn off the system.
1.
If the problem still can't be fixed, please use a pin to press the reset key to turn off the system.
2.
English
Video Cam Lens
Power button
SD Card Slot
Reset Key
Battery Recharge
LED
Power On LED
Mini USB
Power Jack
- 3 -

1.3 Annual Product Calibration

As the product is a high-precision instrument, please use it cautiously. To ensure the
accuracy of measurements, annual calibration is recommended. Please consult the agent or
the customer service department for the calibration service.

1.4 Product Notes and Precautions

1. MK350S Premium Spectrometer is a high-precision instrument. Please unpack with care.
Any vibration or collision may cause instrument damage. If the product doesn't work
normally or needs repair, please don't attempt any repairs. All repairs must be
performed by the authorized customer service agent.
2. Most LCD screens have a very small and inconsequential defective pixel rate (usually less
than 0.1%). This results in occasional pinpoints of white or other colors but will not affect
the accuracy of measurements.
Precautions / Warnings
Please read the following precautions to avoid fire, excessive heat, chemical leakage and
explosion :
Do not disassemble or modify the battery.
■
Do not expose the battery to heat (fire) or water/moisture.
■
When disposing used/old batteries, wrap with insulation tape to shield the battery from
■
electrical contact with metallic objects, which might ignite a fire or explosion.
If the unit is plugged into the power adapter and the battery seems to be overheating, or
■
if there is smoke or peculiar odors emanating from the unit, unplug immediately to avoid
the possibility of fire.
However, do not touch the cables if there is heat emanating from near the cables as
■
melted or deformed cables could expose wiring and result in burns or electric shock.
Do not use cloth or anything to wrap or cover the equipment while charging – this could
■
cause the unit to overheat, melting the casing or causing fire.
If the unit is accidently immersed in water, or if moisture has seeped inside, or metal
■
objects have dropped into the casing, immediately remove the battery to avoid fire or
electric shock.
Do not operate or store the battery in high-temperature environments-it will cause
■
battery leakage and/or shorten the life of the battery .
Do not use paint thinner, benzene or other organic solvents to clean the equipment –
■
this may damage the exterior finish or touch screen, and may even ignite fire.
- 4 -