XPR Access TBS Guia De Inicio Rapido página 2

3.1 View
3.4 Output Connection for AC Device - Fail Secure
TBS operates in Latch and Pulse mode.
The time is set by Dipswitch setting.
Note: Set the operating time only before
switching on power to the TBS.
If the operating time is to be changed,
select a new time setting and then wait a
few seconds for the circuit to re-adjust
before switching back the power.
Warranty: VPC warrants its products to be free from defects in material and workmanship for 24 months from the date of shipment. The product is to be installed in accordance with VPC's
instructions and the unit should not be modified or tampered with. VPC does not assume any responsibility for damages arising from misuse of the product. VPC's sole responsibility is limited to
the repair or replacement when the product is sent to VPC's facility.
Drève Richelle 161, Bâtiment G, WOP - Bte 34, 1410 Waterloo - Belgium
This product herewith complies with requirements of EMC directive 2014/30/EU. In addition it complies with RoHS directive EN50581:2012
3.2 Application & Wiring
3.3 Output Connection for DC Device - Fail Open
Power Supply
~ ~
~
10K 1/2W
470nF
~
4.0 OPERATION
The table illustrates the dipswitch settings in different modes
Operation
Latch Mode
10 Seconds
5 Seconds
3 Seconds
Approvals and Safety standards
Immunity: Meets to EN50082-2 (EN61000-4-2, EN61000-4-3, EN61000-4-4, EN61000-4-5 and EN61000-4-6)
Switch 1
ON
OFF
ON
OFF
2
Access Control Device
Request-to-exit
Input
Locking Device
Relay output
Power Supply
- +
+
-
DipSwitch
Switch 2
ON
ON
OFF
OFF
ON
1 2
ON
1 2
ON
1 2
ON
1 2