Mounting The Sensor - Swann SWIFI-LEAK Guia De Inicio Rapido

• Place the sensor using the included double-sided tape in areas around your home where there is
the potential for water leaks, for example, under the kitchen sink, near the washing machine, next
to the toilet, water heater, etc. Also included is a pack of cable clips to keep the cable tidy and out
of the way.
• Make sure the sensor location has strong, reliable Wi-Fi reception available so you can get timely
alerts. As a general rule, the nearer your sensor is to your Wi-Fi router, the better the wireless
connection quality. You can expand the Wi-Fi coverage of your current network by installing a
Wi-Fi range extender.
• For reliable bonding, clean the mounting surface with an alcohol/cleaning wipe, and let dry.
When mounting the sensor, press firmly to the surface for 60 seconds to ensure proper adhesion.
• Make sure the sensor cover will be accessible in the final position (in case of battery
replacement/re-pairing). For the sensor to activate, the water-sensing metal contacts should
always be placed flat, facing down on the floor.
• To test the sensor, put a drop of water on your finger and touch
the water-sensing metal contacts. The app will send you a push
notification, for example, "Leak has been detected on Laundry Room".
The sensor tile will also automatically update its status in the app, as
shown on the right. Pat dry the water-sensing metal contacts. The app
will send you another notification, for example, "Leak has been fixed
on Laundry Room".
EN
6

MOUNTING THE SENSOR