Diamond GF-1C Manual De Montaje página 16

4 - Recommendations for the User
The boxes have been designed for cooling waste. To ensure that they function well, the following points must be followed:
Avoid opening the doors as much as possible.
•
When putting in the waste, make sure that there is good natural circulation of air inside.
•
Do not use pointed objects to remove
•
If you do not follow the advises above, there will be an increase usage of electrical energy.
•
4.1 - Cleaning
To ensure perfect hygiene and conservation, clean as follows:
Cleaning the surfaces frequently and carefully with a damp cloth.
•
Always when using water and detergent, make sure these are neutral, and avoiding those which are chlorine-based
•
or abrasive.
Rinsing with clean water and drying carefully.
•
It is entirely inadvisable to use pressurised jets of water, specially in the direction of the compressor.
•
5 – Assembly
There is a label on each panel, the darkest side identifies the panel. The dart on vertical panels points to the top.
Proceed to the assembly of the keg box as follows:
Insert the inferior stud-pins in the fixing support of the door (Fig.1);
Put the panel of the bottom on the floor and level it (Fig.2);
MNS00011.01
TEC
Assembly Instructions
1L
2L
Fig. 1
Fig. 2
N.º
MNS00011.01
15/15