Installation Of The Accessories (Optional) - DESKFIT DFT200 Manual

TROUBLESHOOTING:
1. To test if the remote is connected to the treadmill, press the "SPEED +" or "SPEED" button once. A sound
will be played now. If only one sound is heard, there is a stable connection. If a sound is played twice, the
connection is faulty. If no sound is heard at all, reconnect the remote to the device as described above.
2. If the remote control is successfully connected but not working, disconnect the treadmill from the power
supply. Then repeat the connection process.
3. If you press a button on the remote control and the treadmill does not move despite the LED flashing,
change the batteries in the remote control.

INSTALLATION OF THE ACCESSORIES (OPTIONAL)

!
Firmly tighten all component parts and pre-assembled parts!
The handle is not included and can be bought additionally.
To install the handle, follow these 3 steps:
STEP 2
Then fix the handle, the circular seal,
the spring seal and the M8 screw on the
device as shown in the picture.
STEP 1
Remove the 4 screws on the front of the
device using the 5 mm hex wrench.
STEP 3
Then tighten the screws that were just
removed.
29
EN