HANGING METHOD INSTALLATION INSTRUCTIONS
4. UPPER BACK PANEL
The upper back panel (B) has a small tab on the
bottom that fits into the lower back panel (A). Make
sure you have the preassembled hanging rail at
the top on the backside of upper back panel (B) and
the tab facing down. Lift the upper back panel (B)
and position it on the hanging rail (C) and in the
groove on the lower back panel (A). Confirm correct
fit, then remove the upper back panel (A) and apply
a continuous bead of silicone adhesive (D) to the
bottom of the upper back panel (B) and the top of
lower back panel (A). Position the upper back panel
(B) onto the hanging rail (C) and set the groove into
the lower back panel (A). Press firmly to secure, and
cleanup excess silicone adhesive (D) with denatured
alcohol (not included) while the silicone adhesive (D)
is still wet.
4
7
C
B
A
B
D
A
Lowes.com