Metabo BLL 2-15 Instrucciones página 8

en
Main applications:
Operating modes
The BLL 2-15 can be used in 2 operating modes:
B1
1. As easy-setup floor line laser 2. As tile laser combined with special base
B2
for layout work
Commissioning
C1
The instrument is switched on with the on/off switch (1). Laser lines appear
aft er switching on. An angle of 90° is thus projected on the floor. The inter-
section of the laser lines enables easy alignment and measuring. The BLL 2-15
can be set up very close in a corner. The locating edges for the base correspond
C2
to the position of the laser lines. Measuring tools and, if required, a target
C3
plate make a fully accurate alignment to the surroundings (corner, wall etc.)
possible. The BLL 2-15 can therefore be aligned to a reference plane.
C4
Operating mode as floor line laser
The base is positioned with its locating teeth upwards below the laser device.
D1
The BLL 2-15 is easily set up and aligned at a mark.
C1
Operating mode as tile laser
The interchangeable base enables exact positioning at the edges of tiles/slabs.
D1
The BLL 2-15 can be positioned to the side of a tile / within several tiles.
D2
Changing over the base with the locating teeth downwards allows the BLL
2-15 to be positioned on a tile as well.
D3
The laser lines are therefore aligned accurately with the tile edges, while
D4
projecting extension lines precisely onto the floor.
D5
D6
Checking the calibration
The floor line laser BLL 2-15 is designed for use on construction sites and left
our factory perfectly adjusted. As with any precision instrument, however,
its calibration must be regularly checked. The unit should be checked before
starting any new tasks, particularly when the unit has been exposed to
strong vibrations.
8
base enabling exact positioning for
edge-precise alignment of tile layouts