Listening To Your Ipod - HMDX Audio HMDX-SBOX Manual De Instrucciones E Información De Garantía

Charging your iPod
The Portable Mini-Boombox comes with four dock inserts. See chart below
to determine the size insert you should use.
Insert Label iPod Model
Video 60G (160 & Classic) iPod Classic (120 GB, 160 GB 2009; 160 GB 2007)
Nano 4G iPod Nano 4th Generation
Nano 5G iPod Nano 5th Generation
Touch 2G iPod Touch 2nd Generation
The mini-boombox comes with the Apple 5th Generation Nano already
installed in the dock. When you want to connect a different size iPod, remove
the insert from the Mini-Boombox and replace with the correct size insert. To
remove dock insert, place fingernail in slot on insert (Fig. 5) and gently pull up.
You must always use the appropriate size insert for your iPod. You may contact
HMDX Audio Consumer Relations at 1-800-466-3342 to order the correct insert for
your iPod.
Note: Make sure you are using the correct insert for your iPod and that it is
properly docked in the Mini-Boombox. Failure to do so may damage your iPod.
WARNING:
INSERT AND PIN CONNECTOR ARE DESIGNED FOR
APPLE iPOD MUSIC PLAYERS ONLY. ATTEMPTING TO ATTACH OR
FORCE ANY NON-iPOD MUSIC PLAYER INTO THE ENCLOSED INSERT
OR ONTO THE PIN CONNECTOR WILL DAMAGE AND EVEN DESTROY
YOUR DEVICE.
6
1. Before you begin, remove your iPod from its case
or 'skin'. Place insert in dock, being sure that the
two plastic tabs face the front of the unit. Press
insert into place, ensuring it is firmly placed in the
dock. Carefully place your iPod into the docking
area so that the pin connector in the dock is fully
connected to the pin socket on the bottom of
your iPod (Fig. 5).
2. Your iPod will then begin charging, until fully
charged.
NOTE: Your iPod will charge even if the POWER
button is turned off. The Mini-Boombox must be plugged in to
the wall outlet for the iPod to charge. iPod will not charge on
battery mode.

Listening to Your iPod

1. Press the POWER button on the Mini-Boombox (Fig. 1).
2. Toggle through the MODE button to play the iPod (Fig. 1). The IPOD icon
will appear on the LCD display on the left side of the clock, to indicate that
the iPod mode has been selected.
Note: When the iPod is docked and in standby mode, it will
automatically begin playing once the iPod mode is selected on the unit.
3. Press the PLAY/PAUSE button on your iPod to pause play; press play again
to resume play.
4. Press the VOL+/VOL – button (Fig. 1) on the unit to adjust the system
volume.
5. Press the NEXT/PREV button on your iPod to go to the next or previous
track.
6. To turn unit off, press the POWER button. The iPod will continue charging in
the dock.
7
Figure 5