Getting Started - Aleratec 350135 Guia De Inicio Rapido

Getting Started

Loading the Hard Drives
1. Open the drive tray doors by lifting the tab on the left side of each drive bay you wish to use.
2. Take the Hard Disc Drive (HDD) and align the drive's SATA plug to the lower right hand side of the drive bay.
3. Slide the HDD into the drive bay until it stops. The drive will still be about 1 inch outside of the bay. When the door is closed it
will push and plug the HDD into the duplicator.
4. Swing the drive bay door closed and press the left side of the door until the tab latches. When it latches, a click can be felt and
heard. Note: If you are duplicating, the source hard disk drive goes in the top bay.
Copy HDD
The "Copy" function performs a copy from a source HDD to one or more target HDDs. The target HDDs must be at least as large
as the source. The HDD Copy Cruiser High-Speed WL will copy every block of capacity on the source HDD.
1. Load the source HDD and the target HDDs into the HDD Copy
Cruiser High-Speed WL. The system will auto-detect the hard
drives. After the drives have been detected, a screen similar
to the one to the right will be displayed.
Note: Before copying be sure that the capacity of the target HDD is equal to or larger than the source hard drive.
2. Press OK to start copying. The system will auto-detect the hard drives. The following information will be displayed.
Copy
Searching Source
Analyzing Source
Partition #1
3. During the copy process the HDD Copy Cruiser High-Speed WL will
display progress information.
The amount of data remaining to be transferred (shown in gigabytes),
and time will be displayed as the percentage of completion increases.
Note: The copying speed, capacity and duration may vary from one
hard drive to another.
4. Once duplication is complete, a job status screen will be displayed.
Please refer to the User Guide found on the disc
for more detailed information.
Technical Support Addresses and Phone Numbers
• By e-mail: support@aleratec.com – Skype: support.aleratec.com
• By Telephone: +1-818-678-0484 – FAX at: +1-818-678-0483
• Technical Support Group can be reached 8:00 AM to 5:00 PM, Pacific Time, Monday through Friday, excluding U.S. holidays.
Please try to call from a phone near your computer system.
Access is available 24 hours a day, 365 days a year, via The World Wide Web at: www.aleratec.com
© 2014 Aleratec, Inc. 9851 Owensmouth Avenue / Chatsworth, CA 91311 U.S.A.
Specifications subject to change without notice.
OK

ESC
OK
25%

ESC
2014/10/07 10:50
1. Copy
Copy
Analyzing Source
Copy 50.9G
1 Ready
Copy x 11
7:35 26%
Pass: 1 Fail: 0
Time: 20:18
Document Number:
OK

ESC
OK

ESC
OK

ESC
OK
50.9 G
13.5 G

ESC
OK

ESC
350135-350136_ENG_QSG_Rev_A