SPIT TRIX 160 Instrucciones Del Manual De Usuario Y De Mantenimiento página 10

SETTING UP: DRILLING AT AN ANGLE OF 0° TO 45°
1) Loosen the fixing bolts of the locking clamp with the capstan wheel.
2) Incline the column at the desired angle. Securely retighten the fixing bolt.
The depth (or length) of the bore is restricted when drilling at an angle. It will be
necessary to use a bit extension.
MAINTENANCE
Always keep the rig clean, especially the column, the gear rack and the four rollers.
Never oil or grease these three components.
For the best results, the rollers to move the carriage must travel perfectly along the
column.
Adjust the rollers as follows:
Check the carriage for proper guidance and travel.
Oil the leveling screws of the base plate.
Dispose of your appliance, accessories and packaging in an environment-friendly
manner.
6
1
- Using two flat 19 mm spanners, loosen each of the nuts on the side of the
carriage marked "E".
- Retighten each of the nuts while ensuring that the hexagonal shafts are held
in the previously determined positions.
2-3