Troubleshooting Guide; Regulatory Information - Health Zenith SL-6136 Manual De Instrucciones

SYMPTOM
Appliance does
not come on.
Appliance does not turn
off.
Appliance comes
on randomly.
The user is cautioned that changes or modifications not expressly approved by the
party responsible for regulatory compliance could void the user's authority to operate
the equipment.
This device (Model 6136) complies with RSS-210 of Industry Canada. Operation is
subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Range .............................................................. Up to 100 feet (30.5 m)
Rated Voltage ................................................. 120 VAC, 60 Hz
Maximum Load SL-6136 ................................. 500 Watts
Maximum Load SL-6138 ................................ 150 Watts
Battery ............................................................. 9-volt alkaline
Heath/Zenith reserves the right to discontinue products and to change specifications
at any time without incurring any obligation to incorporate new features in products
previously sold.

TROUBLESHOOTING GUIDE

If you experience a problem, follow this guide.
POSSIBLE CAUSE
1. Circuit breaker or fuse is turned off.
2. Switch on appliance is turned off.
3. Lamp or appliance is defective.
4. Signals from remote switch are being blocked, or
remote switch is out of range. Check for metal ob-
jects that could block the signal, or reposition the
remote switch.
5. Weak battery in the remote switch.
1. Switching too fast. Wait 3 seconds before switching
the remote switch.
2. Same as 4 & 5 above.
1. Short term power line failure.
2. Another remote switch on the sam

Regulatory Information

SPECIFICATIONS
incandescent
400 Watts TV
300 Watts fluorescent
1/3 H.P. motor
incandescent
-3-
e channel.