Installation And Connection - NEPTUN classic NCTP-O 300i Instrucciones De Uso

- GB -
Intended use
NCTP-O 300i, referred to as "unit", may only be used as specified in the following:
 For operation with clean water.
 Operate in accordance with instructions.
The following restrictions apply to the unit:
 Do not use in swimming ponds.
 Never use the unit with fluids other than water.
 Never run the unit without water.
 Do not use for commercial or industrial purposes.
 Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
 Do not connect to the domestic water supply.

Installation and connection

WARNING
Death or serious injuries from hazardous electrical voltage due to operation of this unit in a swimming pond.
 Never operate this unit in a swimming pond.
How to proceed:
 B
1. Set the flow rate:
– Turning the socket clockwise: Increases the flow rate.
– Turning the socket counterclockwise: Decreases the flow rate.
2. Fit the hose onto the outlet.
 C
3. Install the pump fully submerged.
– Ensure that the maximum permissible submersion depth of 1 m is not exceeded
– Route the power cable so that it forms a loop below the power socket.
Commissioning/start-up
NOTE
Never allow the pump to run dry. Otherwise the pump will be destroyed.
 Ensure that the pump is always flooded during operation.
 Regularly check the water level.
 Switching on: Insert the power plug into the socket.
– The unit switches on immediately.
 Switching off: Disconnect the power plug.
- GB -
11