Volvo Penta 3862101 Instrucciones De Montaje página 7

22362
22366
6. Install and tighten the hose nipple from the
kit into the tee as shown.
22363
7. Place one of the small hose clamps over
the end of the heater supply hose.
8. Install the heater supply hose and clamp on
the nipple as shown and tighten the clamp.
22364
9. Reinstall all parts removed earlier from the
drain hole. The parts are installed in
the tee as shown. Tighten the fittings
and any parts attached to them.
10. Locate a straight, vertical area where the
T-pipe can be installed in the large hose
connecting the circulation pump and
thermostat housing, (see note).
11. Cut out a 1.50 inch (38mm) section of the
hose as shown.
7