Kress Robotik MISSION NANO Guia De Inicio Rapido página 8

Verification
Before it starts mowing for the first time, make sure Mission
toys and branches...Before starting your Mission
than 10cm. If longer, use a regular mower to cut it before operating Mission
shorten the height of your grass, it is recommended that you do so progressively, by adjusting the cutting
height in steps.
1
Set the cutting height to the maximum level (60mm).
2
Place your Mission
the charging base.
3
Press until Mission
8
use, input the default PIN code 0000 by pressing
En
for four times when the number 0 is blinking.
NOTE: When Mission
on the display will be illuminated and then turn
off. Check if there is any light damaged. It is
recommended to shield the display with your hand
when the outdoor light gets too strong.
NOTE: Mission NANO will turn off if it does not
TM
receive any input within 30 seconds after it is
turned on. If you enter wrong PIN code three times,
Mission NANO will raise the alarm "di-di" and then
TM
turn off.
4
Press then
the charging base. Mission
boundary wire to the charging base.
5
Press and , Mission
to end work of the day .
NANO a few meters in front of
TM
NANO turns on. For the first
TM
NANO turns on, all lights
TM
to send Mission NANO back to
TM
NANO will follow the
TM
NANO can be forced
TM
NANO's working area is clear of objects such as
TM
NANO for the first time, make sure your grass is no longer
TM
NANO. If you want to drastically
TM
Only for reference