Hiltron security DXR4 C1A Manual Del Usuario página 2

security
Made in Italy
BT2014/35/UE
EMC2014/30/UE
Estimated duration of battery: at least 2 years (1 minute/day operating)
Lithium battery type CR2032-3Vdc
Bidirectional system radio
High immunity to RF noise 30Vm
Operating frequency 433,92Mhz multichannel (8 channel) bidirectional
Box ABS
Operating temperature 0°C ÷ +50°C
Safety degree 1
Ambiental class 2
Dimensions (WxHxD) 44x59x10mm
Approved directives CEI EN 50131-1
BATTERY REPLACEMENT
Unscrew the screw located on the bottom of the remote control to open the box, remove the old battery and
insert a a new battery, respecting the polarities indicated on the box.
When the battery is inserted, the LED on the remote control must emit a flash: if not, disconnect the battery
and wait a few seconds before inserting it again.
Check the correct functioning of the two buttons before closing the box.
PROGRAMMTION
Press both buttons for a few seconds, until the LED stays on,
then release them.
Program the radio control with the System Code using the two
button:
- Left button:
- Right button:
If the data entry is suspended for more than thirty seconds, the LED flashes for a few seconds and
automatically exits the programming phase without changing the pre-existing code.
In the event of an error, data entry can be interrupted by pressing the two keys simultaneously for a few
seconds: the LED flashes for a few seconds and the programming is interrupted. At the end of the entry of a
correct code, the LED emits a single flash and ends the programming phase.
In case of incorrect code (all zero or all one) the LED flashes for a while and exits the programming
phase without accepting the code.
Press a button pressed for a long time the relative command is sent for 15 times, then the radio control
waits for the release of the key before allowing a new transmission. This function is useful to prevent
unnecessary battery consumption if a button is inadvertently pressed.
CAUTION !
! !
Lead free
Pb
Twin channel radio control for PROTEC4GSM -PROTEC8GSM
RoHS
compliant
for insert "1".
for insert "0".
DANGER OF EXPLOSION
This product uses a LITHIUM battery.
During replacement, handle the battery carefully and insert it
correctly
for programming
use only the lower
keys
DXR4
"1"
"0"