Be Cool SLAM Instrucciones página 15

Two seat angle: baby can lie or recline.
8
Battery installation and dismantlement: As shown in below picture, push negative pole of
9
battery into with negative pole of battery jar (the side with spring) till battery positive pole is
connect to positive pole of battery jar to install the batteries.
Take off the battery from positive part and push the spring of the battery jar to dismantle the
batteries.
FALL HAZARD: Discontinue use of swing while infant can roll over or push up on hands and
knees. Never place the swing on countertops, table, on or near steps or on other elevated
surfaces. ALWAYS use on the floor.
SUFFOCATION HAZARD: NEVER use on soft surface, such as a bed, sofa, or cushion, as seat my
tip over and cause suffocation.
PLEASE use and assemble this swing as instructions, Be Cool will not be responsible for any
wrong operations.
MAINTENANCE
Keep the metal parts clean and dry to prevent rusting. Grease the mobile parts and mechanisms
regularly with a silicone based spray. Do not use oil or grease. To clean the plastic parts just use
mild detergent and warm water. Do not expose the upholstery to sunlight for long periods of time.
The upholstery may be taken off for washing.
15