Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

MODEL
79V / 79W
Single Pole (One location)
4-Speed, Quiet,
Ceiling Fan/Light Control
Fan Control
Rating: 1.5A-120VAC, 60Hz
Full Range Dimming
Incandescent Lamp Load
Rating: 300W-120VAC, 60Hz
INSTALLATION INSTRUCTIONS
DI-41X-RTD01-12B
99042152G
BROAN-NUTONE ONE YEAR LIMITED WARRANTY
Broan-NuTone warrants to the original consumer purchaser
of its products that such products will be free from defects in
materials or workmanship for a period of one year from the date
of original purchase. THERE ARE NO OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO,
IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE.
During this one-year period, Broan-NuTone will, at its option,
repair or replace, without charge, any product or part which is
found to be defective under normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP
STARTERS AND TUBES. This warranty does not cover (a) normal
maintenance and service or (b) any products or parts which have
been subject to misuse, negligence, accident, improper mainte-
nance or repair (other than by Broan-Nutone), faulty installation
or installation contrary to recommended installation instructions.
The duration of any implied warranty is limited to the one-year
period as specified for the express warranty. Some states do not
allow limitation on how long an implied warranty lasts, so the
above limitation may not apply to you.
BROAN-NUTONE'S OBLIGATION TO REPAIR OR REPLACE, AT
BROAN-NUTONE'S OPTION, SHALL BE THE PURCHASER'S
SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY.
BROAN-NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL,
CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF
OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE.
Some states do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitation or exclusion
may not apply to you.
This warranty gives you specific legal rights, and you may also
have other rights, which vary from state to state. This warranty
supersedes all prior warranties.
To qualify for warranty service, you must (a) notify Broan-NuTone
at the address or telephone number below, (b) give the model
number and part identification and (c) describe the nature of any
defect in the product or part. At the time of requesting warranty
service, you must present evidence of the original purchase date.
Broan-NuTone LLC, 926 West State Street, Hartford, WI 53027
(1-800-637-1453)
• Controls a dimmer and fan in a single gang wall box
• Full range rotary dimming
WARNING: TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH APPROPRIATE ELECTRICAL CODES AND REGULATIONS.
WARNING: IF YOU ARE NOT SURE ABOUT ANY PART OF THESE INSTRUCTIONS, CONSULT A QUALIFIED ELECTRICIAN.
WARNING: TO AVOID OVERHEATING AND POSSIBLE DAMAGE TO THIS DEVICE AND OTHER EQUIPMENT, DO NOT INSTALL TO CONTROL A RECEPTACLE,
FLUORESCENT LIGHTING, A MOTOR- OR A TRANSFORMER-OPERATED APPLIANCE OTHER THAN APPROPRIATE CEILING FANS AND INCANDESCENT LAMPS.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, THIS CONTROL IS TO BE USED WITH CEILING FANS THAT ARE MARKED AS SUITABLE
FOR USE WITH A SOLID-STATE FAN SPEED CONTROL AND ARE RATED 120 VOLTS AC, TOTAL LOAD 1.5 AMPERES MAXIMUM.
WARNING: FOR USE ON CEILING PADDLE FANS WITH SPLIT-CAPACITOR OR SHADED POLE MOTORS ONLY. PLEASE REFER TO FAN MANUFACTURER'S
INSTRUCTIONS OR RATING LABEL ON THE MOTOR TO CONFIRM TYPE. USE WITH ANY OTHER TYPES OF MOTORS OR EQUIPMENT MAY CAUSE
OVERHEATING AND/OR DAMAGE TO THE MOTORS OR EQUIPMENT.
OTHER CAUTIONS:
1. USE ONLY ONE (1) SPEED CONTROL PER FAN.
2. DISCONNECT POWER WHEN SERVICING FIXTURE.
3. USE THIS DEVICE ONLY WITH COPPER OR COPPER CLAD WIRE. WITH ALUMINUM WIRE USE ONLY DEVICES MARKED CO/ALR OR CU/AL.
MULTI-GANG INSTALLATION:
There is NO derating necessary for multi-gang installations of this Quiet Fan/Light Control.
TO INSTALL:
1. WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT
BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE WIRING!
2. Remove existing wallplate and switch, if applicable.
3. Remove 5/8" (1.6 cm) of insulation from each circuit conductor. Make sure the ends of wires
are straight.
4. Connect wires per appropriate WIRING DIAGRAM as follows: Twist strands of each lead
tightly and, with circuit conductors, push firmly into appropriate wire connector. Screw
connectors on clockwise making sure no bare wires show below the wire connectors. Secure
each connector with electrical tape.
5. Installation may now be completed by carefully positioning all wires to provide room in outlet box for control. Mount
control into box with mounting screws supplied. Attach wallplate.
6. Restore power at circuit breaker or fuse. Check for proper operation as follows:
Dimmer:
Rotate top knob control clockwise and counter-clockwise and ensure that the lights DIM or BRIGHTEN accordingly.
Fan Speed:
Position the bottom knob to each of the four levels: MAX, HIGH, MEDIUM and LOW (refer Figure 1). Ensure that fan
speed changes accordingly.
7. INSTALLATION IS COMPLETE.
TO OPERATE
Dimmer:
• Rotate top knob control clockwise
- Lights will BRIGHTEN accordingly
• Rotate top knob control counter-clockwise
- Lights will DIM accordingly
• Rotate top knob control fully counter-clockwise
- Lights will turn OFF
Fan Speed:
• Rotate bottom knob control to each of the four levels; MAX, HIGH, MEDIUM,
and LOW
- Fan will increase or decrease in speed respectively for desired level.
• Rotate bottom knob control to OFF position
- Fan will turn OFF.
TROUBLESHOOTING
• Fan does not turn ON or does not run Multispeed
- Circuit breaker or fuse has tripped.
- Fan is not connected to line Neutral.
- Switch on Fan not set to HIGH position.
- Fan and light miswired.
• Light does not turn ON
- Circuit breaker or fuse has tripped.
- Bulb has burned out.
- Lamp is not connected to line Neutral.
- Switch on Fan unit controlling Light is not in the ON position (if applicable).
- Fan and light miswired.
FEATURES
• Four Preset fan levels
• Ideal for any area where ceiling fan noise is distracting
INSTALLATION INSTRUCTIONS
WIRE CONNECTOR / # OF CONDUCTOR COMBINATION CHART
1- #12 w/ 1 to 3 #14, #16 or #18
2- #12 w/ 1 #14 w/ 1 #16 or #18
2- #12 w/ 1 #16 w/ 1 or 2 #18
2- #14 w/ 1 to 3 #16, #18 or #20
4- #16 w/ 1 or 2 #18, #20 or #22
1- #14 w/ 1 to 4 #16, #18 or #20
2- #14 w/ 1 to 3 #16, #18 or #20
Wiring Diagram 1 - Single Location Control Application
2- #14 w/ 1 #16 w/ 1 or 2 #18 or #20
3- #14 w/ 1 or 2 #18 or #20
4- #14 w/ 1 #16 or #18
2- #16 w/ 1 #18 w/ 1 or 2 #20 or #22
1- #14 w/ 1 #18 w/ 1 to 3 #20
3- #14 w/ 1 #16 w/ 1 #18, #20, #22
3- #14 w/ 1 #18 w/ 1 #20 or #22
Figure 1 - Fan Speed Control Functions

Publicidad

loading

Resumen de contenidos para Broan 79V

  • Página 1 This warranty supersedes all prior warranties. - Fan and light miswired. To qualify for warranty service, you must (a) notify Broan-NuTone • Light does not turn ON at the address or telephone number below, (b) give the model - Circuit breaker or fuse has tripped.
  • Página 2 Para tener derecho al servicio de la garantía, usted debe (a) notificar El conmutador del ventilador no está ajustado en la posición ALTO. a Broan NuTone a la dirección y número de teléfono que aparecen El ventilador y la lámpara se conectaron incorrectamente.

Este manual también es adecuado para:

79w