Southwire M300P Instrucciones De Uso página 3

Tester Description
Cable Tester Top View
3.
1.
2.
1. Voice - RJ11/RJ12 Jack
2. Data - RJ45 Jack
3. Video - F connector
4. CYCLE button
5. MODE button
6. LCD display
7. Detachable Remote
8. Rotary Function Switch
Detachable Remote
Bottom View (7.)
(A). Voice - RJ11/RJ12
(B.) Data - RJ45 Jack
Included:
RJ45
Remote
ID's:
5 numbered Remote ID's
permit mapping 5 remote locations.
An Expansion Kit is available for a
maximum of 16 remote locations.
M300P
4.
CYCLE MODE
Voice Pass Fail Test
Data Rev Short
Video Shield Open Tone
Split ID 1
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
A.
B.
F-Connector
Remote
ID's:
5 numbered Remote ID's
permit mapping 5 remote locations.
An Expansion Kit is available for a
maximum of 16 remote locations.
3
Symbols Used on LCD Display
1.
2.
8.
3.
5.
1. Voice: Appears when testing or toning a phone cable.
6.
2. Data:
Appears when testing or toning a network cable.
3 Video:
Appears when testing or toning a coax cable.
4. Test:
Indicates cable test is in process.
5. Tone:
Appears when the tone generator is activated.
- Pass: Indicates proper wiring on cable being tested.
- Fail: Indicates wiring error on cable being tested.
- Rev: Indicates the connections on one or more pairs
is reversed at one of the cable.
- Short: Indicates that two or more wires are shorted to each other.
- Shield: Appears when the cable being tested has a shield that
is connected at both ends. The Shield indicator will flash
if there is a short between the shield and any wire within
the cable.
- Open: Appears when one or more pairs are open.
Pass Fail Test
Voice
Data
Rev Short
Open
Video Shield Tone
Volt! X-over Split ID 1
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
4
4.
5.