Installing And Operating Your Fridge Freezer - SUNFEEL FG1702X Manual De Instrucciones

Frigorífico combi dos puertas congelador - frigorífico
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• When removing ice from the ice-making compartment, do not touch it. Ice
may cause frost burns and/or cuts.
• Do not touch frozen goods with wet hands. Do not eat ice-cream or ice cubes
immediately after you have taken them out of the ice-making compartment.
• Do not re-freeze frozen goods after they have melted. This may cause
health issues such as food poisoning.
• Do not cover the body or top of fridge with lace. This affects the performance of your
fridge.
• Secure any accessories in the fridge during transportation to prevent damage to the
accessories.

Installing and operating your fridge freezer

Before using your fridge freezer, you should pay attention to the following points:
• The operating voltage for your fridge freezer is 220-240 V at 50Hz.
• We do not accept responsibility for any damages that occur due to ungrounded usage.
• Place your fridge freezer where it will not be exposed to direct sunlight.
• Your appliance should be at least 50 cm away from stoves, gas ovens and heater cores,
and at least 5 cm away from electrical ovens.
• Your fridge freezer should never be used outdoors or exposed to rain.
• When your fridge freezer is placed next to a deep freezer, there should be at
least 2 cm between them to prevent humidity forming on the outer surface.
• Do not place anything on your fridge freezer, and install your fridge freezer
in a suitable place so that at least 15 cm of free space is available above it.
• Do not place heavy items on the appliance.
• Use the adjustable front legs to make sure your appliance is level and stable.
You can adjust the legs by turning them in either direction. This should be done before
placing food in the fridge freezer.
• Before using your fridge freezer, wipe all parts with a solution of warm water
and a teaspoon of sodium bicarbonate, then rinse with clean water and dry.
Place all parts in the fridge after cleaning.
• Install the plastic distance guide (the part with black vanes at the rear)
by turning it 90° (as shown in the figure) to prevent the condenser from
touching the wall.
• The refrigerator should be placed against a wall with a free space not
exceeding 75 mm.
EN - 37 -

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido