Product Information - Trust GM-3200 Manual Del Usuario

USER'S MANUAL

Product information

A: Race wheel
B: Feet pedals
C: USB PC connector
Installation PC
1 (1)Turn on the PC. (2) Connect USB to PC.
2 USB wheel ready to use.
3 Open Game Controllers in Windows Control Panel. Test all functions here.
Settings for PC and Playstation2
Press Select+D-pad (right) to cycle through sensitivity settings:
Level 1: blue LED
4 Level 2: green LED
Level 3: red LED
Note: Level 1 least sensitive and level 6 most sensitive. After few seconds red LED light again.
Press Select+D-pad (up) for 1 second to switch on/off the vibration feedback:
5
All 3 LEDS will flash 3 seconds for confirmation
Feet pedals are hot swappable. Hand levers functions:
6 Pedals connected:
Pedals not connected: Hand levers "F" and "G" function as throttle and brake.
Programming buttons: (∆, O, X,
Step1: Press Select for 3 seconds
Step2: Press button you want to change
Step3: Press button of the function you want to assign
7 (All 3 LEDS will flash 3 seconds)
Step4: Press Select to Exit programming mode.
Pressing Mode button for 3 seconds will reset all programmed button to their default setting.
(Red LED will flash 3 seconds)
Level 4: blue and green LED
Level 5: green and red LED
Level 6: blue and red LED
Hand levers "F" and "G" have same functions as ∆ and O
, L1, R1, L2, R2)
1
D: Playstation2 connector
E: Table clamp UK