Fan controller for Irid 400 PC case.
Instruction of use
NOTE: The controller is pre-installed and ready to use, once connected to the power supply. The battery compartment of the
remote has a removable plastic tab to isolate the battery power. Remove the plastic tab (by pulling it out completely) to begin
using the controller.
Overview of the controller:
POWER – Connect this cable to the output cable of the power supply units, using a MOLEX 4-pin 12 V connector. A MOLEX 4-pin
to SATA interface adapter is included.
RESET SW – Optionally, you can plug-in 2-PIN RESET connector from PC case front panel. By default slot is not used - this function
is covered by remote.
DATA – This cable ends with two plugs:
PWM: Can be connected to a compatible PWM 4-pin connector on the motherboard (check the motherboard user manual to see
if the socket supports PWM or DC). It allows BIOS to take control over fan speed. If not connected, the fans operate as set by the
remote or the controller.
ARGB: A 3-pin 5 V plug. After plugging into compatible motherboard socket (check the motherboard user manual to see if ARGB
3-PIN is supported), the LED lighting of the fans can be controlled by the BIOS or motherboard software tools. Supports Asus Aura,
MSI Mystic Light, and more.
FAN 1-8
6-pin fan power sockets. To expand the product with more fans, connect the fans to the sockets, one by one. Do not plug fan
connectors leaving unused sockets between them.
The controller is compatible with Genesis Irid 400 fans for the Irid 400 case. Compatibility with other 6-pin power connector fans
is not guaranteed (even if their connections match those of the controller).
Plugging-in an incompatible fan may result in failure of the fan and/or controller.
LED
The "LED" sockets support LED strips with ARGB A 3-pin 5 V connectors.
Controller panel buttons
- LED SPEED changes the lighting colour change rate
- MODE selects the lighting colour mode
- FAN SPEED adjusts the fan speed
EN
PL
DE
ES
CZ
SK
RO
HU
BG
RU