Blueant Wireless RIBBON Manual Del Usuario página 4

Charge the Ribbon
The Ribbon has been given an initial partial charge, but for best
results we recommend you fully charge it using the supplied
USB cable and adaptor.
> A full charge takes about 2 hours.
> During charging, the indicator light is solid red.
> When the light goes solid white, the charge is complete.
> The Ribbon features an iPhone battery meter so you can
check your battery status at a glance.
Pair Your Phone or Bluetooth Streaming Device
To get started you need to pair the Ribbon with your phone or
device.
1. Hold down
fl ashing to switch the Ribbon on and go straight to pairing
mode.
2. Go to your phone or device's Bluetooth menu.
3. Select Pair
4. Select the BlueAnt Ribbon.
Note: If requested, the pairing code is
4
for about 3 seconds until the LED starts
or Add New Device.
0000 (four zeros).