PNI PTV35 Manual De Usuario página 7

Charging methods
1. Direct charging: connect the 230V power adapter directly to the robot
cleaner.
2. Charging command from remote controller: Press the key
robot cleaner to the charging base.
3. Automatic charging: when the battery level drops below 20%, the robot
cleaner will go to the charging base on its own.
Notes:
• Keep the charging base always powered, otherwise the robot cleaner will not be
able to find it.
• To extend battery's life, use the battery as it is charged by the factory for the
first time. After discharging, charge the battery at least 5 hours before the next
use.
The LED indicator CLEAN
• Low battery: red led
• Charging in progress: the red LED flashes
• Fully charged battery: green led
Note: if the robot is turned off from the on/off (I/O) button on the side of the robot,
the CLEAN LED indicator will remain off regardless of the battery status.
On/Pause/Off
1. Turn the on/off button on the side of the robot to the On (I) position. The
robot will turn on and enter standby mode. The CLEAN LED will turn
green. You will also hear the voice confirmation "Welcome to use robot
cleaner. I'm happy to serve you."
2. Press the CLEAN button or the on/off key on the remote control. The
robot will start working. You will hear the audio confirmation "Begin to
clean".
3. Pause the robot by pressing the CLEAN button or the key on the remote
control again. You will hear the voice confirmation "Cleaning is suspended".
4. If you do not use the robot for a while, it will enter Sleep mode. If the
battery drains below 20%, you will receive a voice warning. We recommend
7
to send the
User manual