Siefken SCHOCK DÄMON SD75 Instrucciones página 23

3 YEARS
L I M I T E D WA R R A N T Y
3. Under normal operation, the machine is designed to produce vibration, the screws and bolts
can come loose, causing a breakdown and accidents. Check tightness of them carefully before
running.
4. In cold weather or a long time tool not be used, please keep the tool running without load a
few minutes to warm up the grease inside, otherwise hammering function is di cult to get.
5. Be sure you stand stably and no one is below when you using tool is in high location.
6. Hold the tool rmly with two hands.
7. Don't touch any moving parts.
8. Don't leave the tool running itself, operate tool only when hand-held.
9. Don't point the tool to anybody for the bit could y out in case.
10. When chipping into walls, oors or wherever "live" electrical wire may be encountered, DON'T
TOUCH ANY METAL PARTS OF THE TOOL! Hold the tool by the insulated grasping surface to pre-
vent electric shock if you chip into a "live" wire.
11. Don't touch the BIT OR PARTS CLOSE TO THE BIT immediately after operation, they may extre-
mely hot and could burn your skin.
12. Any damage and abnormal happen, please stop to use immediately and disconnect it, ask
authorized serve center to check and repair.
13. Parts replace: Only original
can be used to replace by authorized service center.
14. Right use accessories and parts: Don't use other parts and accessories which not mentioned
in the manual otherwise may cause injuries!
15. Special attention to voltage: Before connect the power tool, please make sure the rated volta-
ge on the tool can match the power supply, otherwise the power tool may be damaged and
cause injuries.
16. Don't wipe plastic part with solvent: Solvent such as gasoline, thinner, alcohol etc. these kind
of chemical material, are not allowed to use, water or soap are recommended!
17. In case of damages the replacement of the plug or the supply cord shall always be carried out
by the manufacturer of the tool or his service organization
Residual risks
Even when the power tool is used as prescribed it is not possible to eliminate all residual risk
factors. The following hazards may arise in connection with the power tool's construction and
design:
a) Injuries and damage to property to due to broken accessories that are suddenly dashed.
b) Health defects resulting from vibration emission if the power tool is being used over longer
period of time or not adequately managed and properly maintained.
6