Cleaning; Troubleshooting - Wilfa POWER FUEL XL Manual De Instrucciones

USING THE TAMPER
The tamper is to be used for stirring food. Never use the tamper without the lid
in place. Remove the filler cap from the lid and slide tamper into the Blender Jar.
The tamper has a splash guard located near the top that prevents the tamper
from coming in contact with the blade assembly.

CLEANING

Always clean the removable parts immediately after use.
• Disconnect the power from main supply.
• Disassemble all removable parts before cleaning.
• Clean all removable parts in lukewarm water with dishwashing liquid.
• The blender jug can be rinsed with water. It can also be cleaned by pouring
2 cups of water into the blender jug, closing the lid and then operating the
blender in Pulse Mode. Then pour out the water, rinse with water, and dry with
a soft cloth.
• Use dry cloth to clean the main body.
Note: Be careful when cleaning the parts. Avoid touching the sharp blades!

TROUBLESHOOTING

If the blender is not working properly, please check the following:
Problem
Blender does not
start
Blender stops
Content does not
blend properly
POWER FUEL XL · PB1S-P2000, PB1B-P2000
Possible reasons
Check the power plug
Check if the jug is
properly placed
The blender has run
more than 10 minutes
Motor is overheated:
The motor has stopped
temporarily due to
overload
Not enough fluid
11
Solutions
Plug into power socket
Place the jug correctly on the
motor unit
Let the motor cool down
Reduce the amount of
ingredients and wait for the
unit to cool down
Use the tamper, or consider
adding more fluid in the jar to
help circulation
EN