Nahita ZFD014 Manual De Uso página 10

b. The cursor will flash at "U=□□□V". Set the value of constant voltage by pressing
"▲"or"▼"button.
c. The cursor will flash at "I = □□□mA" when press "ENT" button. Set the value of constant
current by pressing "▲"or"▼"button.
d. The cursor will flash at "P = □□□W" when press "ENT" button. Set the value of constant power
by pressing "▲"or"▼"button. The range of power can be set from 1 to 300W.
The cursor will return and flash at "U = □□□V" when you press "ENT" button. Set the value of
constant voltage again by pressing "▲"or"▼"button.
e. Power supply in Setting State now:
Press "RUN/STOP" button, it will enter into Operating State.
f. Power supply in Operating State now:
Press "RUN/STOP" button, it will stop output and return to Setting State.
g. In Setting State, continue to press "EDIT" button, it will enter into Editing State and display:
"SAVE [□]" → "LOAD [□]" → "T= □□:□□" → "QUIT" → "SAVE [□]"...
h. At "SAVE □", press "▲"or "▼" button to select number of memory program. The range of
number is from 1 to 9. Then press "ENT" button to save current method into this program.
At "LOAD [□]", press "▲" or "▼" button to select number that needed. The range of number
i.
is from 1 to 9. Then press "ENT" button to load the current method from program.
At "T= □□:□□", press "▲"or "▼" button to set operating time.
j.
k. The range of timer is from 1minto 99hs and 59mins. Then press "ENT" button to save it.
At "QUIT", press "ENT" button to quit Editing state, and return to Setting State.
l.
Versión/Version
EDIT[0]
U= 100V
I= 500mA
P= 300W
EDIT[ 0 ]
U= 100V
I= 500mA
P= 300W
EDIT[ 0 ]
U= 100V
I= 500mA
P= 300W
referencia/Code ZFD014
RUN!
00:01
100
V
350
mA
35
W
0
V
0
mA
0
W
0
V
0
mA
0
W
11/07/2017
10